Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 18.06.2025 00:44

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

There are three different concepts here that are getting confused.

But… the neutral is now “floating” because of the 1 ohm resistance.

This one hit behind the barn.

We white women don't like white men. Do you have any issue with that?

A fuse is a non-resetable over current circuit protector.

Here is a simplified AC power diagram.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

I feel so attached and in love with a dead celebrity. My love for anyone else is overshadowed by my love for him. What does this mean?

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

(Dc diagram shown, AC is similar).

Why does Islam give a bad vibe?

[image of Common-mode choke]

2024–10–14 [Omar Gharbi Omar Gharbi ]

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Why did you choose not to join Mensa?

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

This is where the MOV conducts again, and dissipated the energy.

It also is a device that limits the change in current flow.

The Fog of Trade War Is Causing Confusion About Price Increases - WSJ

This is 'the assistant's answer'

He then asserts :

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

Why are there posts saying the T in LGBT should be dropped? With what is happening in the US and beyond against the trans community cause for concern that if this is accepted could it be deemed acceptable to start on the LGB community again?

What is lightning?

Because the load is inductive, the current lags the voltage.(by a bit).

So, the voltage could go up to 500 volts, and the fuse will not open up.

Have you ever met someone and something seemed so unusual about them but you couldn't put your finger on what it was?

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

2024–10–10[John johnson John Johnson ]

The bolt then partially travels down the line to your home.

What are the withdrawal symptoms of Klonopin 1mg?

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

An AC voltage/ current source, and an ac inductive load.

Barnstars:

Do you suck dicks with no reciprocation?

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

These are simplified answers to the original question, and does not change anything I wrote above.

What are some common examples of condescending behavior?

He then describes the function of a fuse.

This is where this question deviates from being a 'generic' question, and becomes more specific.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

If my heart stopped beating, would I have enough energy to walk out into the other room 20 ft away before I passed out and died?

What does a fuse do?

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

This device then solves the entire problem.

What are some of the best photos of your favorite Korean model?

the problem then depends on "how fast does the fuse operate?".

but this device (an Inductor) … impedes the rapid changes in the current.

At least they know the answer if they wanted it.

Why is it after eating almonds when I’m occupied, I don’t feel mild itch, but as soon as I have nothing to do, I feel mildly itchy?

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

The #1 High-Protein Snack for Better Blood Sugar, According to a Dietitian - EatingWell

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

Edit 2024–10.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

nine

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

Upvotes:

One is “what exactly is in a ‘surge protector’ ? ”

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

But it can get overloaded, and no longer works.

Now when you have a certain ac resistance, then a current flows in a loop.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

For this case there are devices called Metal oxide varistors (MOV).

2024–10–16 [ OO OLAOYE OYEBODE ]

There are two important concepts here.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

what exactly is a ‘surge’ protector?

He then describes Rainy Season and Lightning.

These devices are installed between the “hot” and “neutral” and protective ground.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

First Sentence:

This is the picture of an electronic coil of wire wound around a core of magnetic material.

The other is “what does a “fuse” do?”

A circuit breaker is similar, but is resettable.

a photo is worth a thousand words.

so, what happens?

Can the fuse protect the electronic devices from lightning instead of a surge protector.

I post the exact comment here.

At one ohm, the resistor has a maximum of 1 watt power.

One

In schematic diagrams this is the symbol for a fuse:

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

It seems Mohan does not understand the difference between a comment and an Answer.

eight

but I think this circuit , shows a few more pieces.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

[old diagram got deleted by accident]

The third is lightning and “how it gets conducted into a home.”

The MOV will conduct when the voltage exceeds 50% of line voltage.